Get emailed when a booking hits an error in Simpro
A failed booking email goes to your staff when a booking has recorded an error against it. The page says it is triggered on any error, and that a Simpro project and schedule may still be created.
Before you start
- Notifications need a Service booking form subscription. Without one the Notifications tab shows "Want to receive booking notifications?" and nothing on it can be edited.
- Add at least one service on Services.
Step by step
- Open your form from Forms and click the Notifications tab, then Failed notifications.
- Click Add failed booking recipient.
- Type an address in Recipients (to) - at least 1 required and press Enter. Add Recipients (cc) and Recipients (bcc) if you want them.
- Choose the Services - at least 1 required.
- Click Create failed notification recipient. It stays disabled until there is a to address and a service, unless the form has no services.
- Click Save. The page says "Recipients updated."
The Active switch pauses a recipient, and Delete removes one after a "Confirm delete" prompt. The empty list reads "No failed booking recipients found."
What the email says
A recipient is emailed for a booking on one of their services. A booking with no service goes only to recipients who have no services selected, which is only possible on a form without services.
The email opens by saying errors occurred while saving the booking in Simpro, and that some data may have been saved before the error. Under that it lists:
- The form's name.
- The details ticked for failed emails on Email content. By default these are the service, the customer's name, the date, the preferred date and the Simpro job or quote number.
- Whether the schedule was created in Simpro, as "Created (ID ...)" or "Not created".
- A link to the booking in the dashboard.
- A table with one row per error, naming the Simpro record that failed and the message Simpro returned.
The subject reads like "Failure on Heater service booking from Jamie via Formpiece" unless you change it. Message only or Full response on Email content decides whether the error rows show Simpro's message or the raw response.
When it goes wrong
I got an email but the job exists in Simpro
That is expected. Each step of the booking is saved as it goes, so an error late in the booking can leave a customer, site, job or quote already created. Open the booking from the link in the email and check Integration Errors to see what was made before you enter the booking again by hand.
A customer's booking failed and nobody was emailed
- Nobody is set up on this page for the service that was booked.
- The recipient is switched off.
- The submission was refused before it was saved. Those are logged on the Attempts tab, and no email is sent for them.
The email arrives for a booking that looks fine
It is triggered on any error recorded against the booking, whether or not the Simpro job looks complete. Read the error table in the email to see which step failed.